7 Color L.E.D. undercar lighting
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Apr 2004
Location: Dallas, TX
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
7 Color L.E.D. undercar lighting
I purchased a L.E.D under body kit and I need advice installing it. Each tube has to be connected to the distribution block by way of the inch and a half wide connectors. The distribution block has to be mounted inside the car to minimize heat and weather exposure. This is where I see a problem. Where can I cut a hole big enough to run the connectors through with out worrying about water coming through. I have searched the firewall up and down looking for a plug or grommet big enough but no dice. Any help in this matter would be greatly appreciated.
#3
Senior Member
Posts like a Corvette
Join Date: Oct 2002
Location: N.W. Indiana
Posts: 1,206
Likes: 0
Received 0 Likes
on
0 Posts
That is going to be your best bet. Just tie the wires into to each other. That way you wont a need a big hole to send them through, and then you can use the rest of the distribuiton block for neons inside the car or whererver. Put go through thr rubber boot on the drivers side right underneath the brake cylinder.
#4
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Apr 2004
Location: Dallas, TX
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
If I tie the wires all together, will I still have the functions of changing the color and scan as well as having it light to the music?
Thread
Thread Starter
Forum
Replies
Last Post