Ignition Switch Harness
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Mar 2009
Location: Ohio
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Ignition Switch Harness
i just bought a remote starter for my 03 se, took all the trim under the steering wheel out, and now i don't know which bundle of wires are for the ignition switch
#2
Senior Member
Posts like a Turbo
Join Date: Dec 2006
Location: Cincinnati, Ohio
Posts: 484
Likes: 0
Received 0 Likes
on
0 Posts
Start from the ignition switch and work backward. Let me know what wires you are trying to tag and i will give you the colors for each and their location.
#3
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Mar 2009
Location: Ohio
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
ok...found which wires i need to use, but now i can't figure out how to remove the ignition switch itself, because it would be much easier to access the wires with it out. I've removed the bolts from the front and now i can't figure out how to get the ring around the keyhole out, because it won't come out without taking this piece off.
#4
Senior Member
Posts like a Turbo
Join Date: Dec 2006
Location: Cincinnati, Ohio
Posts: 484
Likes: 0
Received 0 Likes
on
0 Posts
Are you talking about the plastic ring that has the marks that indicate start, accessory...? You honestly shouldnt have to pull the whole switch out because all the wires should be pretty easy to grab once you remove the under dash
#6
Senior Member
Posts like a Turbo
Join Date: Dec 2006
Location: Cincinnati, Ohio
Posts: 484
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, it shouldnt be that bad. two 7 or 8 mil bolts and the top is held in by a sort of body clips on the seam just below the where the steering column disappears under the dash. Let me know what wires you need to tag and ill tell you what each one is
Thread
Thread Starter
Forum
Replies
Last Post
trigga_b
Audio (and aftermarket electronics)
15
10-23-2007 02:44 PM