Removal of Factory radio In PA 97 tips
03-24-2014, 02:47 PM
#1
Member
Posts like a V-Tak
Thread Starter
Removal of Factory radio In PA 97 tips
Replacing radio in my 97 Park ave and front/back speakers any tips on removal process and or things to look out for?
03-24-2014, 10:55 PM
#3
Senior Member
Certified GM nut
Certified GM nut
you need to do a LOT of hollowing out. gm put a cubby where the stereo goes.
as for the rear speakers, you need to use a pair of needle nose pliers to remove the center part of each push pin that holds the speakers in. dont break these, as gm charges an astonishing $4.00 for EACH ONE!!! and its next to impossible to find any at any parts store.
here is a picture of my cubby in order to fit my stereo. once i got an amp and had to run RCA preouts, i had to remove the duct looking thing. there are about 50 wires running thru that duct, so be careful if you need to cut it out.
as for the rear speakers, you need to use a pair of needle nose pliers to remove the center part of each push pin that holds the speakers in. dont break these, as gm charges an astonishing $4.00 for EACH ONE!!! and its next to impossible to find any at any parts store.
here is a picture of my cubby in order to fit my stereo. once i got an amp and had to run RCA preouts, i had to remove the duct looking thing. there are about 50 wires running thru that duct, so be careful if you need to cut it out.
Thread
Thread Starter
Forum
Replies
Last Post
GunsOfNavarone
Audio (and aftermarket electronics)
0
11-29-2014 08:20 AM
SSEimatt93
Detailing & Appearance
11
08-21-2006 07:19 PM
