79ford |
05-08-2003 06:07 PM |
Ok, I'll go into a little more detail on how I wired these. On the drivers side I used the stock red wire as positive and the other wire as negative - does this make a difference? On the passenger side I tried both wires as positive and couldn't really hear a difference. Which is supposed to be positive? Next I wired positive from crossover to the red terminal on the mid speaker and negative to black. Finally, if I remember right, I used the wire with the black stripe as negative for the tweeter and without stripe for positive. If this is incorrect Please tell me.
On the crossover, I placed the bare ends of the wires into the holes and then tightened the screws. I am thinking about undoing this and putting the wires directly under the screw heads on the top of the crossover plate. Would this make better contact? I don't think there could be any crimped wires etc. as the speakers worked fine with the stock speakers. I should probably just dump the whole lot and start over!
Ok, thats long enough. Thanks.
|