GM Forum - Buick, Cadillac, Olds, GMC & Pontiac chat

GM Forum - Buick, Cadillac, Olds, GMC & Pontiac chat (https://www.gmforum.com/)
-   Audio (and aftermarket electronics) (https://www.gmforum.com/audio-aftermarket-electronics-101/)
-   -   Das Buick has bump!! (https://www.gmforum.com/audio-aftermarket-electronics-101/das-buick-has-bump-304679/)

eltatertoto 02-25-2013 07:54 PM

Das Buick has bump!!
 
6 Attachment(s)
hey guys, just posting because im excited about my $5 sub system. got the subs in the pics, plus an offbrand one and the amp in trade for my cruzin cooler about a week ago. then i got the line out converter and the amp install kit for free thanks to autozone rewards. so ive only got the $5 i paid for the cooler at goodwill in this. which im excited about.

i took a few pics and a vid of the install. (yes i know i rednecked it by running it under the car, but it was about 10 times easier that way.)

Attachment 15864

Attachment 15865

Attachment 15866

Attachment 15867

Attachment 15868

Attachment 15869

vids got explicit lyrics, nsfw!
here is the video link. my apologies for the sound. or lack of it. i didnt realize my camera couldnt handle those low frequencies. it just kindof mutes it when it gets loud.

2 10s in a buick - YouTube

Soft Ride 02-25-2013 08:50 PM

I like it when it costs little with trades and you end up with boomer sound.
With the redneck wire install, just consider getting a rubber grommet where it enters into rear floor & it sealed.
I had to look twice on your rear bumper...woh.

eltatertoto 02-25-2013 09:09 PM

lol. its just airsoft. had it in my pocket from earlier and just set it down there.

Soft Ride 02-25-2013 09:15 PM

Oh I thought it was a larger caliper and that is what you used to make the hole in the rear floor !!:D

ymmot04 02-25-2013 09:36 PM

Eeek! That wiring looks like a fire waiting to happen. Should be run inside the car with the rest of the wiring (on the opposite side of the car from the RCAs). It's not very hard to pull it through the firewall then pull up the trim and tuck it along the doors. One small cut in that wire and you can ground against the frame and best case scenario you blow the fuse, worst case your car burns to the ground. Would hate to see anything happen to that beautiful car of yours, or worse, to its passengers.

Soft Ride 02-25-2013 09:55 PM

Hopefully it is just temporary Tom. I think Jason just want to get to hear it ASAP.

eltatertoto 02-25-2013 10:31 PM


Originally Posted by Soft Ride (Post 1577081)
Hopefully it is just temporary Tom. I think Jason just want to get to hear it ASAP.

yep. just wanted something out of the way till i can get it jacked up good. i very highly doubt it will scrape in the mean time though. its completely run along the brake lines apart from about 4 inches though and i live in indiana... no hills anywhere. lol.

as for the hole, i used some rtv. and it was a preexisting hole, didnt shoot my car. haha.

SignOfZeta 02-26-2013 12:02 AM

Can't really hear it in the video, but as much as those speakers are moving, it should be as good as you say it is.

Now put that wire in the car like you've been told. If you're lifting up the carpet to run a wire, you might find some change to help offset that $5 bill. :mrgreen:

eltatertoto 02-26-2013 12:05 AM

haha. i plan to as soon as the incoming storm passes. it was about an hour from dark and i was in a rush. should be like that less than a week.

on that topic, anyone with my body know a good passthrough to use? if it comes down to it ill just get the 10 ton jack and some stands and crawl up under there and look, but it would be nice to have an area to look for. the whole firewall is covered in insulation so it should be fun without ant pointers. lol.

jwfirebird 02-26-2013 06:35 AM

i normally just drill a hole by the fan/heat duct high enough to not be visible. then tape some stiffer wire like solid 12g to it and stick it in the hole. give your self enough to poke it to somewhere you can reach. pull it in and zip tie it up. then just run it down the pass side under the carpet and run everything else on the driver side


All times are GMT -4. The time now is 09:25 AM.


© 2024 MH Sub I, LLC dba Internet Brands