How to take out?
#2
Senior Member
Posts like a Camaro
Join Date: Nov 2007
Location: MN
Posts: 1,172
Likes: 0
Received 0 Likes
on
0 Posts
Move your shifter back to 2 or 1.. pull out the clip on the front of the shift **** with a needle nose pliers, and pull the **** off. there Is a bolt or 2 in the ashtray also, IIRC.
after that, it should lift up pretty easily.
after that, it should lift up pretty easily.
#4
if done it several times, but I don't have step by step instructions. you will need to remove the shifter **** like Bonnevillan noted, and you will also have to remove the dash trim to access the 4 bolts that hold the console to the dash. then remove the shifter plate. there are 4 bolts on the bottom of the console, all on the outside of the console. disconnect the wiring and shift cabes and it should come out.
why are you taking it out?
why are you taking it out?
#5
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Dec 2005
Location: jersey
Posts: 740
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Andrew I knew you would know...I'm taking it out cause 1 I have a leak coming some were from my bottom and I need to pull back the carpet and also I am getting a 04 center consule and new front carpet
You know how I would be able to find a leak coming from under the carpet on the bare metal?
You know how I would be able to find a leak coming from under the carpet on the bare metal?
#6
its probably not coming from the floor... read this: http://www.bonnevilleclub.com/forum/...ic.php?t=70801
#7
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Dec 2005
Location: jersey
Posts: 740
Likes: 0
Received 0 Likes
on
0 Posts
I don't have a sunroof :(
I was thinking at first it could be something wrong with my water shield ( plastic peice behind door panel ) but thats sealed good. And its not wet on the sides just on the floor of the driver side... Any other ideas Andrew?
I was thinking at first it could be something wrong with my water shield ( plastic peice behind door panel ) but thats sealed good. And its not wet on the sides just on the floor of the driver side... Any other ideas Andrew?
Thread
Thread Starter
Forum
Replies
Last Post
TV_PRO_USMC
Audio (and aftermarket electronics)
5
03-07-2005 12:08 AM