PO102 code advise
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2009
Location: Green Bay, WI
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
PO102 code advise
mass air flow sensor..... could it be anything else?
cleaned the MAFS with CRC cleaner, looked clean to begin with.
would any thing else cause this code?
the idle is jumping a grand above normal then dropping and stalling engine, at stop lights and while driving down the road. the tack is all over up and down.
Thanks~
2000 ssei
cleaned the MAFS with CRC cleaner, looked clean to begin with.
would any thing else cause this code?
the idle is jumping a grand above normal then dropping and stalling engine, at stop lights and while driving down the road. the tack is all over up and down.
Thanks~
2000 ssei
#3
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2009
Location: Green Bay, WI
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
should add that this starts acting up only after the engine has reached normal operating temp.
I will unplug the sensor on the way to work tomorrow
I will unplug the sensor on the way to work tomorrow
#4
DINOSAURUS BOOSTUS
Expert Gearhead
#5
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2009
Location: Green Bay, WI
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
stopped by auto zone for a 2nd scan it showed that same code 3 times. yesterday at advanced auto there scanner showed the code one time, dont know if that is telling me anything.
sure wish we scanned cars at Carquest as I mix/tint paint there...
#7
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2009
Location: Green Bay, WI
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
94SSEgold
1987-1991
3
08-24-2003 09:21 PM