2001 bonneville Radio locked or just won't turn on
This last week I installed an aux port got music and everything is hooked up correctly. I just think I triggered the theftlock when I was splitting the radio power wire. Would there be an unlock code for this?
|
GM DELCO THEFTLOCK RADIO UNLOCK CODE:
1. Press and hold presets 2 and 3 for about 5 to 10 seconds until you get 3 digits on your display. This is the first 3 of 6 digits you will need, so write 'em down. 2. After doing step one and writing down the code, immediately press the AM/FM button to get the last 3 of the 6 numbers you'll need, and write 'em down. (if you wait too long between steps 1 and 2 and the LOC code displays again, just start over). 3. Call this number, it's a prerecorded message, so don't worry about having to talk to anyone...1-800-537-5140. The voice will ask if you're calling for Chevy, Pontiac, Cadillac, etc... When you here him tell you to press "2" for Pontiac, press 206010 (account number invalid; 11/25/2008) and hit the # key. He'll ask you for the 6 digit code that you've written down. Enter that and press the * key. He will then give you a code, and the option to get additional 4 digit codes, but one should be sufficient. 4. Follow the normal procedure in your owners manual for unlocking the radio with your new code...press the hour set button on your radio until you get the first two numbers of the code, then press the minute set button until you've entered the last two numbers. Immediately press the AM/FM button once the correct code is entered and the code SEC or "secured" will be displayed on the display screen. Now, just turn the radio on, and your ready to roll. There is an additional step you can take to remove all codes from the radio and start from scratch by entering your own personalized 4 digit code so that it won't get you in a pickle again! Just repeat step 4 and you should get a display screen that reads ---. This means the code is out, and you can now program your own code. Of course, once you receive the 4 digit code from the GM recorded message, just keep it in a safe place, because you can use that same code again and again should you have any more problems with it in the future. Good luck, and yes, it does work. answer B: i jus used this one and workerd just fine 03/02/2010 1. Turn the ignition ON (The radio should display "LOC") 2. Hold down the Radio Presets 2 and 3 buttons for six seconds 3. The radio display changes from LOC to a three-digit number. Write this number down. You now have fifteen seconds to complete the next step. 4. Press the AM/FM button 5. The radio display changes to another three-digit number. Write this number to the right of the first one. 6. You now have a six-digit number, the first three digits are from STEP 03 and the last three digits are form STEP 05 7. Call 1-800-537-5140 8. Press 1 then # (pound). You'll hear "Invalid Code, try again" 9. Press 139010 or 106010 or 206010 or 202107 then # (pound). You will be asked to enter your four or six digit code followed by * 10. Enter the number from STEP 6 then * 11. Listen to the four-digit number and write it down. It will be repeated twice 12. Turn the ignition ON (The radio displays LOC) 13. Use the MN and HR buttons to enter the code from STEP 11 14. Press the AM/FM button. The radio display changes to "SEC". Your radio is now "un-locked" and usable. Dealership Codes 139010 106010 206010 202107 Troubleshooting If you fail to enter the correct code eight times, the radio goes into INOP mode. You have to wait an hour with the ignition on before the radio returns to LOC mode. Read more: http://wiki.answers.com/Q/Unlock_the...#ixzz1UewEGRTD |
My display doesnt say loc on it.
Attached is what the dash looks like. I know it is still getting juice because parts light up. http://imageshack.us/f/191/photo2tai.jpg/ |
|
cant really see the radio in that picture, but it sorta looks like the radio has the display out which is a common problem. usually the rest of the radio still works when that happens though.
https://www.gmforum.com/showthread.p...hlight=display |
x2 that what I was thinking because mines looks the same way, but still works. How you tried turning up the volume.
Also how did you do the AUX mod? I didn't know you could do it through the Headunit |
All times are GMT -4. The time now is 06:55 PM. |
© 2024 MH Sub I, LLC dba Internet Brands