Taking apart Dash
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Jun 2003
Location: Lake Zurich, Il
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Taking apart Dash
I have a 2001 se, i wanted to just add subs to the back, i need to know how to take apart the dash to get to the stereo. Also if anyone who has done this before wants to give me some pointers on what do i.e. remote wire, or what they ran into problems with. It would be much appreciated. Thanks
#2
Senior Member
True Car Nut
Join Date: Jun 2003
Location: Purgatory
Posts: 6,313
Likes: 0
Received 0 Likes
on
0 Posts
To remove the dash,
1. remove outer ignition bezel
2. pop out DIC from lower right hand corner, pry with flat blade screw driver.
3. with steering wheel tilted all the way down pull out the 2 push locks above the instrument panel.
4. pull on the lower trim below enviromental controls to release the last of the retainers.
5. you may have to remove the HUD controls and/or dimmer contols also.
1. remove outer ignition bezel
2. pop out DIC from lower right hand corner, pry with flat blade screw driver.
3. with steering wheel tilted all the way down pull out the 2 push locks above the instrument panel.
4. pull on the lower trim below enviromental controls to release the last of the retainers.
5. you may have to remove the HUD controls and/or dimmer contols also.
#3
Senior Member
Posts like a Northstar
Join Date: Sep 2003
Location: Chicago, IL
Posts: 536
Likes: 0
Received 0 Likes
on
0 Posts
To remove the dash,
1. remove outer ignition bezel
2. pop out DIC from lower right hand corner, pry with flat blade screw driver.
3. with steering wheel tilted all the way down pull out the 2 push locks above the instrument panel.
4. pull on the lower trim below enviromental controls to release the last of the retainers.
5. you may have to remove the HUD controls and/or dimmer contols also.
On the SE. I removed mine on my 2000 SE and I think they are the same.
Do set 3. First. The 2 push locks feel like screws but all you have to do is push them in the center and it will allow you to remove the locks. I used a small flat head screwdriver after 35 mins trying to screw them out.
Then set 4. Make sure to be careful because once you get it lose you have to disconnect the DIC connecter before the dash panel will come completely out. And then the bezel will come off with the dash panel. Was not able to remove before then.
On the SE you don't have to worry about the HUD but that tray like thing will come out with the dash.
An now your at at your radio. You have 4 metal claps that hold it in. Just squeeze then in and slide the radio out. I hope we were able to help.......Holla back
1. remove outer ignition bezel
2. pop out DIC from lower right hand corner, pry with flat blade screw driver.
3. with steering wheel tilted all the way down pull out the 2 push locks above the instrument panel.
4. pull on the lower trim below enviromental controls to release the last of the retainers.
5. you may have to remove the HUD controls and/or dimmer contols also.
On the SE. I removed mine on my 2000 SE and I think they are the same.
Do set 3. First. The 2 push locks feel like screws but all you have to do is push them in the center and it will allow you to remove the locks. I used a small flat head screwdriver after 35 mins trying to screw them out.
Then set 4. Make sure to be careful because once you get it lose you have to disconnect the DIC connecter before the dash panel will come completely out. And then the bezel will come off with the dash panel. Was not able to remove before then.
On the SE you don't have to worry about the HUD but that tray like thing will come out with the dash.
An now your at at your radio. You have 4 metal claps that hold it in. Just squeeze then in and slide the radio out. I hope we were able to help.......Holla back
Thread
Thread Starter
Forum
Replies
Last Post
GXP_Vince
Audio (and aftermarket electronics)
10
06-15-2007 12:16 AM