Which size seperater?
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Mar 2004
Location: Easthampton, Ma
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Which size seperater?
I have a ball joint, tie rod, etc seperator kit it comes with three different forks which one should i use for seperating ball joints and which one to seperate tierod ends from wheel hub assembly. the three sizes are 11/16", 15/16", and 1 1/8". Thanks for any help, i wanna use the right one so i dont damage the tie rod end.
#3
Senior Member
Posts like a Turbo
Join Date: Jan 2004
Location: Saint Paul, MN
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
Not exactly for sure, I would go with what ever one would wedge the best, just use your perception. If all else fails and you have a air hammer I always use the bit that looks like a blade it will hammer the top notch off then use a skinny bit to knock the stud through the hole. The fork wedging idea is pretty good also.
BTW, your removing the ball joint from the knuckle and control arm not the hub.
BTW, your removing the ball joint from the knuckle and control arm not the hub.
Thread
Thread Starter
Forum
Replies
Last Post
<tS>Ace*Of*Spades
Audio (and aftermarket electronics)
6
07-26-2006 07:55 PM
Mark Peters
Performance, Brainstorming & Tuning
10
03-21-2003 08:42 PM