Water in tail light
Upon my car alerting me of a burnt out turn signal bulb I discovered that there was a good amount of water in the tail light. My dad said that one solution would be to drill a small hole in the bottom of it, but he said to see if any of you guys know a better method. Thanks!
|
water in tail light
my 92 did that and it turned out there was microtiny crack in my top part of the lamp where the trunk shuts. i went to a yard and found one cheap.
try looking for a crack or something, see if water is coming through the lightbulb sockets themselves, that could be it too. this kinda stuff is always fun, good luck :D |
The most likely entry point is the seal between the light assembly and the rear of the car. Take them out, clean the seals and the paint, and apply a little RTV before you reinstall them.
|
I ended up having both a crack and bad seals on my tails.
Crack was just about the "shopping cart height" (lucky me) RTVed the seals and crack, good as new........ |
All times are GMT -4. The time now is 04:26 PM. |
© 2024 MH Sub I, LLC dba Internet Brands