Throttle Body Removal
Thread Starter
Junior Member
Posts like a V-Tak
Joined: Apr 2007
Posts: 26
Likes: 0
Throttle Body Removal
Just started teardown for UIM/LIM gasket replacement. Lower throttle body mount bolt
a bear to get to along with bottom rear stud turning. Read earlier posts of removing crossover duct. What works in these tight areas? Universal 8MM:? What about stud
turning. Upper is about ready to come off. Called it a day.
a bear to get to along with bottom rear stud turning. Read earlier posts of removing crossover duct. What works in these tight areas? Universal 8MM:? What about stud
turning. Upper is about ready to come off. Called it a day.
Senior Member
Posts like a Northstar
Joined: Sep 2005
Posts: 600
Likes: 3
From: Dayton, OH
Re: Throttle Body Removal
Originally Posted by Buddy
Just started teardown for UIM/LIM gasket replacement. Lower throttle body mount bolt
a bear to get to along with bottom rear stud turning. Read earlier posts of removing crossover duct. What works in these tight areas? Universal 8MM:? What about stud
turning. Upper is about ready to come off. Called it a day.
a bear to get to along with bottom rear stud turning. Read earlier posts of removing crossover duct. What works in these tight areas? Universal 8MM:? What about stud
turning. Upper is about ready to come off. Called it a day.
I had a short box wrench to use on it also. There was just enough room. I didn't have any touble with the studs for those three turning.
Thread
Thread Starter
Forum
Replies
Last Post
DeeGee96SE
Performance, Brainstorming & Tuning
5
Jun 29, 2004 12:21 AM