no spark
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Dec 2006
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
no spark
I got a 95 bonnie that won't fire. Had low fuel pressure, changed the pump, now have no spark. Have no voltage on pinkl wire. what is the checklist I should go through to narrow this down.
Can you check for signal from the crank and cam sensors at the icm plug in? the book shows ins, and I get voltage at the cam sensor in port.
Can you check for signal from the crank and cam sensors at the icm plug in? the book shows ins, and I get voltage at the cam sensor in port.
#5
Junior Member
Posts like a Ricer Type-R
That'* a specific fuse that will prevent a 12v feed to the ICM pink wire. I'm not talking about the main fuse panel. These fuses are hidden where I described them. This fuse is on the PASSENGER side of the vehicle below the glovebox. Did you check all those? Most people don't even know they exist.
#6
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Dec 2006
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
I checked all the fuses I could find with ign related, in drivers kick panel, pass side under the panel. still no fire, all other electrics work as far as I can tell, windows, seats, radio, instruments, fuel pump primes.
I am wondering if the key is bad, but the manual says the fuel system is cut when the key is bad. The security light goes off too. Is the igniton system disabled as well. Can the sec sys. be bypassed?
I am wondering if the key is bad, but the manual says the fuel system is cut when the key is bad. The security light goes off too. Is the igniton system disabled as well. Can the sec sys. be bypassed?
#7
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Dec 2006
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
I also checked the icm for ground and it checked out, would that eleminate a grounding issue. does power run to the icm through pcm? would it do serious damage to splice a known powered wire to the icm to see if it will run?
#8
Senior Member
Certified GM nut
Join Date: Oct 2005
Location: Western New York
Posts: 1,942
Likes: 0
Received 0 Likes
on
0 Posts
Moose, was the key in the run position when you checked for power at the pink wire that connects to the ICM?
You can remove fuse #6 on the passenger side & test for power at the fuse block. One side of the fuse block terminals should have 12 volts with key on.
You can remove fuse #6 on the passenger side & test for power at the fuse block. One side of the fuse block terminals should have 12 volts with key on.
#10
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Dec 2006
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
I have power to the fuse in run. Still nothing at icm. Knew had power because fuel pump was priming. Is there a relay between the fuse and the icm?