How to Remove Dash Trim???
10-19-2003, 10:38 AM
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Aug 2003
Location: Maumelle, Arkansas
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
How to Remove Dash Trim???
Hey everyone. I am wondering how to remove my dash trim from my radio/heater on my 93' Bonneville SSE. I have the bass boost slide switch and it looks like the **** is bigger than the dash trim hole. Does it just snap off or what?... Thanks for you help.. 
10-19-2003, 11:18 AM
#3
Member
Posts like a V-Tak
Join Date: Sep 2003
Location: Oregon
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
Don't do anything with the bass switch!
Just pry VERY CAREFULLY all around the woodtrim in the area of the controls then follow it in the strip over the steering column. You don't have to pry it out very much for the clips to loosen but some require a lot of force. Careful not to mar the thin edge of the plastic. I use thin non-pointed kitchen knives. Once you get that big panel loose undo the wiring connector from the back of the bass switch. There'* a release tab to push up from below.
Good luck.
Just pry VERY CAREFULLY all around the woodtrim in the area of the controls then follow it in the strip over the steering column. You don't have to pry it out very much for the clips to loosen but some require a lot of force. Careful not to mar the thin edge of the plastic. I use thin non-pointed kitchen knives. Once you get that big panel loose undo the wiring connector from the back of the bass switch. There'* a release tab to push up from below.
Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
singscountry1967
Detailing & Appearance
6
01-29-2007 12:38 AM