codes
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Mar 2004
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
codes
My 94 SSEi is having some intermittand cutting off issues, engine light coming on. Here are some codes the dealer pulled off... any ideas?
P0321
P0341
P1361
P0321
P0341
P1361
#2
Senior Member
True Car Nut
Join Date: May 2003
Location: Lethbridge, Alberta, _______Canada._______ West Coast Bonneville Fest ___05,06,07 Survivor___
Posts: 8,135
Likes: 0
Received 0 Likes
on
0 Posts
I had a look in my chiltons and scanned a page for you, I sent it via PM
Code PO341= CMP sensor circut performance.
Code PO341= CMP sensor circut performance.
#3
Yes, one of the three you mentioned or bad wiring connections... Those codes need a good diagnostic from the service manual... Although he said the engine was cutting out... Does that usually mean one of the two sensors?
#4
Member
Posts like a V-Tak
Thread Starter
Join Date: Mar 2004
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
I should mention that the ignition module has been replaced at least once already (I think 2 times actually). Also, would any of the codes be set off by a bad harmonic balancer? I know the crank and cam sensor are behind it. I'm about to replace it b/c the outer pulley surface is 100% detached from the inner core.
#5
Member
Posts like a V-Tak
Thread Starter
Join Date: Mar 2004
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Well..I was already planning to replace the crank sensor and have it already. So, when the harmonic balancer gets swapped, so will the sensor. Worth doing the cam sensor too??? I know that the ignition control module has been replaced a few times and the code still keeps popping up.
hmmmm
hmmmm
#6
Member
Posts like a V-Tak
Thread Starter
Join Date: Mar 2004
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
update on issues
Hey all....I got my car all back together. When I took off the old balancer, there was actually a "tooth" from the crank sensor that was knocked off so I'm sure that wasn't working correctly. Anyways, after cranking her up...the check engine light still pops on. The stalling is intermittant, so I have no clue if that'* been rectified. I'm going to take it to autozone and see if they can pull codes from it. It'* a 94 w/ OBD I but OBD II connection..so hopefully they can help. I did NOT replace the cam sensor, but if that code still exists I'll replace it probably. sound reasonable?? any advice is well received. Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
RyanSSEi
1992-1999
1
12-16-2002 02:06 PM