Can anyone help answer this possible misfire problem????
#1
Senior Member
Posts like a Supercharger
Thread Starter
Join Date: Feb 2004
Location: Clarkston, Michigan
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
Can anyone help answer this possible misfire problem????
If i put it in first or sound gear and hold the gas at one steady RPM it will like pause or misfire but does not sound to misfire just fells like it does.I can tell a lot more now that i have put a flowmaster 80 series on because it changes the exhaust tone when it happens. It does not have any problem at WOT. Still very quick not showing any power loss at any RPM but it'* noticed at low speeds and lower RPM. what would cause this. Complete tune up done less than 10,000 miles ago. read in sig for plugs and wires.
Thanks
Ryan
Thanks
Ryan
#2
Senior Member
True Car Nut
Join Date: Jun 2003
Location: Purgatory
Posts: 6,313
Likes: 0
Received 0 Likes
on
0 Posts
What rpm range does this happen? Are you pulling or cruising when it studders?
It sounds like the ignition, although new check and make sure the wires are properly seated, look for any nics in the wires too.
Do you still have the original fuel filter? Maybe the fuel preassure is low untill your into wot?
It sounds like the ignition, although new check and make sure the wires are properly seated, look for any nics in the wires too.
Do you still have the original fuel filter? Maybe the fuel preassure is low untill your into wot?
#3
Senior Member
Certified Car Nut
r 2) Bosch Platium +4 spark plugs 3) Bosch Premiuim wire set
Otherwise if you notcied it with the flowmaster it could be backpressure related.
Thread
Thread Starter
Forum
Replies
Last Post
JLAudioEclipse
Performance, Brainstorming & Tuning
11
02-13-2004 09:44 AM