New clunk
#1
Senior Member
Certified Car Nut
Thread Starter
New clunk
In the last few days, I've noticed a new clunk. Sometimes when I put it in gear, sometimes when I hit a bump, sometimes for no appearant reason at all, just moving. Definatly in the front, seems like it'* coming from the passenger side. I was under it last Saturday and checked out my motor mounts like I always do while I'm down there, they seemed fine. Struts were replaced all around last Fall.
Any thoughts?
Any thoughts?
#2
DINOSAURUS BOOSTUS
Expert Gearhead
Have an assistant watch the motor when you move the selector from D to R and back. Visually inpecting a motor mount is good, however you can not always see a bad mount.
Check CV boots etc for signs of an axle going.
Check CV boots etc for signs of an axle going.
#6
yeah i had a kinda clunk problem..and i regreased my upper strut bearings and i no longer have a clunk when i hit a bump..so yeah...other than that i would not know, but hey, it fixed my clunk...
EDIT: just wanted to let you know...they were TOTALLY dry..and that will cause a clunk..so yeah,
EDIT: just wanted to let you know...they were TOTALLY dry..and that will cause a clunk..so yeah,
#10
Senior Member
Certified Car Nut
Thread Starter
Could be, they were replaced with Monroe uppers when I had the struts done. I'll pop the tower cap off and give it a good shot of WD-40. I haven't noticed any difference cold or hot.
Thread
Thread Starter
Forum
Replies
Last Post