stripped screws
03-09-2004, 11:59 PM
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: May 2003
Location: Toronto
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
stripped screws
okay, i went to adjust my headlights and the screws/nuts were stripped. even trying pliers they were too tight to move. any suggestions?
03-10-2004, 02:04 AM
#3
Junior Member
Posts like a Ricer Type-R
That won't work for what he'* doing.
Use a light oil to lube the screws, especially where the go through the blocks. Let it sit for at least an hour, then use a torx bit to try to break them free. You may have to buy the proper tool.
If they are too bad, after lubing, just bite the bullet, and use vise-grips to turn them.
Use a light oil to lube the screws, especially where the go through the blocks. Let it sit for at least an hour, then use a torx bit to try to break them free. You may have to buy the proper tool.
If they are too bad, after lubing, just bite the bullet, and use vise-grips to turn them.
Thread
Thread Starter
Forum
Replies
Last Post