I Think its Dead....
#1
Senior Member
Posts like a Camaro
Thread Starter
Join Date: Apr 2006
Location: Coon Rapids, Minnesota
Posts: 936
Likes: 0
Received 0 Likes
on
0 Posts
I Think its Dead....
So yea i was getting ready to the MN meet when i took off to the gas station and my friend said that i was blowing smoke.... so i came home any it was running really bad. i shut it off. when back after it cooled off and it wouldnt start.
I just replaced the spark plugs, plug wires and changed the oil like 2 weeks before this happend.
So smoke + oil covered new plugs + used a ton of coolant + no start = What????
I just replaced the spark plugs, plug wires and changed the oil like 2 weeks before this happend.
So smoke + oil covered new plugs + used a ton of coolant + no start = What????
#3
Junior Member
Posts like a Ricer Type-R
DRAIN YOUR OIL IMMEDIATELY BEFORE YOU RUST YOUR CRANK AND ROD BEARINGS.
Do NOTHING else after reading this except to IMMEDIATELY drain your oil. You cannot afford to ruin your engine. Remove all 6 spark plugs as well.
Do NOTHING else after reading this except to IMMEDIATELY drain your oil. You cannot afford to ruin your engine. Remove all 6 spark plugs as well.
#5
Senior Member
Posts like a Camaro
Thread Starter
Join Date: Apr 2006
Location: Coon Rapids, Minnesota
Posts: 936
Likes: 0
Received 0 Likes
on
0 Posts
i think im too late to drain the oil... this happend on the 5th. looks like ill get my moneys worth for the warrenty....
#6
Junior Member
Posts like a Ricer Type-R
Originally Posted by 92BonneSE
Ok, not to hijack your thread but I want to ask a few questions. If you know the answers, please PM them to me so I dont take over this thread
On the 1998
1. Upper intake manifold was replaced at 58,755 miles. It was replaced on 9/9/03. Is it possible the newer design of the manifold wasn't out yet and its still the old design that is prone to fail?
2. Lower intake gasket, this has to be done also correct?
3. Anything else I have to worry about/replace in the engine so it doesn't throw a rod or blow?
On the 1998
1. Upper intake manifold was replaced at 58,755 miles. It was replaced on 9/9/03. Is it possible the newer design of the manifold wasn't out yet and its still the old design that is prone to fail?
2. Lower intake gasket, this has to be done also correct?
3. Anything else I have to worry about/replace in the engine so it doesn't throw a rod or blow?
#7
Senior Member
True Car Nut
Originally Posted by GreenMachine98
i think im too late to drain the oil... this happend on the 5th. looks like ill get my moneys worth for the warrenty....
oh its under warranty Ok you for sure lucked out then, Hopefully they will give you a crate engine for it.
#9
DINOSAURUS BOOSTUS
Expert Gearhead
There is one thing you'll need to ensure they realize the upper failed. In some cases if they don't see many 3800'*, they may not realize why and just swap the parts onto it.
Thread
Thread Starter
Forum
Replies
Last Post
TDS-94SSEi
Audio (and aftermarket electronics)
6
07-27-2005 07:22 PM
coyote
Bonneville GXP/ Northstar Powered Cars
2
05-31-2005 12:13 AM