Keyless Entry
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: May 2003
Location: jacksonville, florida
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
Keyless Entry
I will be reprogramming a new remote today and my question is what is the procedure if the DCL does not have any pins in it to connect the jumper wire to? I took a look at it the other day, and it seems to have metal contacts but I don't remember seeing any pins. My instructions say to connect the jumper to terminals 4 and 8.
#2
I believe for the 94, this is probably the procedure you need.
http://www.bonnevilleclub.com/techinfo/?article=60
Check the pin diagram closely at the bottom.
http://www.bonnevilleclub.com/techinfo/?article=60
Check the pin diagram closely at the bottom.
Thread
Thread Starter
Forum
Replies
Last Post
85bonneville
Audio (and aftermarket electronics)
7
02-24-2003 10:22 PM