K... replaced the front side exhaust manifold on my bonnie last night/this morning lol

god that was fun ... ugh...

unfortunately... its oem, but they did a bad welding job and the egr valve is at an offset angle and i barely got the tube to seat on it and tighten down and its causing a leak around the seal... frankly id rather get rid of the egr valve altogether... i know it can be done on some cars

any ideas how to do it? is there a package or does it have to be fabricated? how would i get rid of the codes... and i kno it will prolly violate some law somewhere, taken into consideration...

I'd talk to Ryan at GMTuners or SinisterPerformance. both the same guy.

He can probably program it out to keep the codes from happening and then you can simply cap it.

how would i cap it on the intake? any ideas?

Pipe fitting with the right threads or back out to the welder. Or run a block of some sort in the EGR tube.