|
I'm going to pull mine, and see how far the hood can travel, and I could really use an extra inch of travel.. would that prevent it from closing properly?
-justin |
shouldnt, but in doing that you must remember that you will be supporting the full weight of the massive hood on these cars. better find you a good broom handle. i have found a 2x4 fits pretty good between the battery and the front end, and is just long enough to take the load off of the springs where you could get them off, but dont quote me on that
|
Even better way if you plan to change them is to open the hood and make sure it is as high as it can go. Use vise grips on one of the sides that are screwed. That will hold the hood up and allow you to remove and replace one of the worn shocks. Then with one new one on that should hold the hood up enough for you to change the other side. If not get that broom handle near by. You DO NOT want to use the vise grips on the new shock as it may put grooves on the new cylinder and cause premature failure.
|
Re: Hood holdup
Originally Posted by opensourceguy
You all probably have this problem too. My hood refuses to stay up anymore.. when it's warm, it is ok.. but it sags, which I don't like, and when cold, it won't stay up for anything. I used a water jug to hold up the hood, anytime I am under it, but I would like a more permanet fix. I have seen the piston things on JCW.. but nothing for any H bodies on there.. anyone know of a size that would work? Or, is there something I can do to mine.. something free would be great :).
-justin I did replace mines (original GM genuine ones) for $32.00 each at http://www.pontiac-parts-dealer.com/ This is the right parts that you only have to install upside/down when replacing the original ones. Ciao! Panda |
I built a custom hood prop out of 5/16 steel rod. Heat it with a torch and bend it all you like. Find a mounting clip from any other car and bolt it to the rad support. Or you can just find a prop rod from another car. It really suits the vintage motif of your car, and the hood will never come crashing down and tear you a new one :wink:
|
heeeeeeeeeeyyyyyyyyy, i might just do that. thats a great idea.
|
That sounds good.. grabbing the hood holdup stick from another car. I bet I could get that cheap too. Just gotta measure first ;). It really sucks right now, with the rear end raised, the hood already feel on me yesterday [with the water jug, attempting to hold it up.. but it just crushed]. Good thing it was slow! There are some really sharp edges on the fender sides of the hood.. they hurt! loL
-justin |
1992+ H-body hood struts should work. I pulled a pair off a '92 LeSabre, at the same time that I pulled my STB.
|
improved design by any chance? Any 92+ er's have this problem? Or even 90+'s but if you've got the prob repin.. must just be something with the gen I guess.. or the age.
-justin |
I have the same problem, and the broomhandle method worked for me :D .
|
| All times are GMT -4. The time now is 06:37 AM. |
© 2024 MH Sub I, LLC dba Internet Brands