looks pretty good


heres how to post pics
http://www.bonnevilleclub.com/forum/...ic.php?t=77281

actually thats what the 4.3L V6 is

...but mine are 6" x 3", so more square inches. :P

What did you use for the Y? Are you still using a cat and resonator?

i bought 2 J-bends(big and small) and a 4ft. straight section of all 3" pipe and a Hi-Flow 3" Stainless steel cat from Summit Racing. used a tiny bit of the J-bends for that U near the Y right under the back seats. then cut out a 3" hole right in the middle of a J-bend and welded the straight pipe into it. thats true 3" to a 3" split. no restriction wut so ever. then i went back to Summit and got these 2 mufflers that had a 3" center inlet and a 3" offset outlet. put those on. then finally went to a shop to put on some straight tips for me. no resonator. tried to explain as clearly as i could. make sense? if it wasnt for that little U bend under the rear seats then my whole exhaust would be perfectly symetrical

You don't happen to have a pic of the stock exhaust all laid out, do ya?

I've got some t-shooting to do, and i'm not sure what to tackle first.

Thanks

i only got pics on my phone. got one of the cat-back laying on the garage floor. gimme ur number and i can pix msg it to u.

The only better thing to do would be to get two of those per side! Otherwise, you have a very nice exhaust!

Take another vid and rev it to 4000 rpm so we can hear the sound better.