Knock sensor resistance test
#1
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Knock sensor resistance test
You have two knock sensors on your engine, one in the front near the starter.
And another near the rear of the engine, near the center between the cross member and oil pan.
Use your DVOM and clip the black probe to a good ground. Set your meter to the 200k ohm scale, skip this if you have a auto scaling meter. Touch the red probe to the terminal in the sensor.
Then check your reading.
And another near the rear of the engine, near the center between the cross member and oil pan.
Use your DVOM and clip the black probe to a good ground. Set your meter to the 200k ohm scale, skip this if you have a auto scaling meter. Touch the red probe to the terminal in the sensor.
Then check your reading.
Thread
Thread Starter
Forum
Replies
Last Post