P0705
09-27-2009, 02:36 PM
#1
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
P0705
P0705
Description
TRANSAXLE RANGE SWITCH CIRCUIT
Transaxle Range Switch (TRS) is part of Park/Neutral Position
(PNP) switch. Inputs from TRS indicate to PCM which position is
selected by gear selector lever. PCM uses this information for
ignition timing, EVAP canister purge, EGR and IAC valve operation.
Combination of 4 TRS input states determine PCM commanded
shift pattern. Input voltage level at PCM is high when TRS is open,
and low when TRS is closed. A problem which causes PCM to detect an
invalid transaxle range input combination will set DTC P0705.
Symptoms
You likely won't notice any drivability problems.
Causes
Description
TRANSAXLE RANGE SWITCH CIRCUIT
Transaxle Range Switch (TRS) is part of Park/Neutral Position
(PNP) switch. Inputs from TRS indicate to PCM which position is
selected by gear selector lever. PCM uses this information for
ignition timing, EVAP canister purge, EGR and IAC valve operation.
Combination of 4 TRS input states determine PCM commanded
shift pattern. Input voltage level at PCM is high when TRS is open,
and low when TRS is closed. A problem which causes PCM to detect an
invalid transaxle range input combination will set DTC P0705.
Symptoms
You likely won't notice any drivability problems.
Causes
- TRS inputs indicate an invalid combination for more than
10 seconds.
- Check if TRS 4-pin harness connector is disconnected or
damaged. - Check for faulty connection at TRS 4-pin and 7-pin
connectors. - Replace TRS.
