Transmission & dyno tune TIME: Ed's Bonne Bulid Up
#81
Senior Member
Certified GM nut
Thread Starter
Join Date: May 2005
Location: Wickliffe, Ohio
Posts: 2,155
Likes: 0
Received 0 Likes
on
0 Posts
SHE'* RUNNING! Got my new starter on and started her with open headers
I'm going to get a video of her firing up and then maybe drive her through the parking lot and then head home.
Ed
I'm going to get a video of her firing up and then maybe drive her through the parking lot and then head home.
Ed
#86
Senior Member
Certified GM nut
Thread Starter
Join Date: May 2005
Location: Wickliffe, Ohio
Posts: 2,155
Likes: 0
Received 0 Likes
on
0 Posts
Took her for a little drive but I'm leaving her at the shop till I can get a case learn later in the week. The Jenny 5 sounds much different then my gen3 on the L67. I did 1 hard pull almost at WOT from 10-50mph and she is way faster then before . I can't wait till I can get my trans and dyno tune!
Thanks for everyone’* help thus far! And thanks to Intense!
Video
There was lots of back round noise and video actually sucks but check it out till I get a better one.
http://www.youtube.com/watch?v=pmcMtgyxSCI
Ed
Thanks for everyone’* help thus far! And thanks to Intense!
Video
There was lots of back round noise and video actually sucks but check it out till I get a better one.
http://www.youtube.com/watch?v=pmcMtgyxSCI
Ed
#88
Senior Member
Certified GM nut
Join Date: Dec 2002
Location: plattsburgh NY
Posts: 2,037
Likes: 0
Received 0 Likes
on
0 Posts
Congrats, sounds great.
Now get some miles logged and get us some speedo shots
PS- I cant wait to get my L67 build going, it is looking early 08 as of right now.
Now get some miles logged and get us some speedo shots
PS- I cant wait to get my L67 build going, it is looking early 08 as of right now.
#89
Senior Member
Certified GM nut
Thread Starter
Join Date: May 2005
Location: Wickliffe, Ohio
Posts: 2,155
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BillBoost37
Why are you running open headers though?
I drove her from the shop to the local GM stealership about a mile away and back. I talked with someone in the service department about getting my case lean. I will have that done Thursday morning. I made a point to say how my pcm “could not be re-flashed” and after the rep talked with a service tech they agreed with my situation. If they didn’t agree I would have gladly gone down the road to another rival GM dealership, lol.
Ed