SOME NEW PICS OF MY HEAD FINISHED
#5
Guest
Posts: n/a
yes it is, the shop that i had cut the seats builds race motors for alot of the stock cars here in this area, they even have an engine dyno in their shop. i kinda felt pretty good when i went to pick them up. the owner asked me if i knew a good tech that was looking for a job and kinda smiled. i told him i was very happy where im at now
made me feel pretty good .
made me feel pretty good .
#8
Guest
Posts: n/a
to use sbc rockers, you need to have the rocker boss machined down, use 92 guide plates, and use markV BBC screw in studs. then once you do this, you need to install them on your motor , using a pushrod length checker and get the proper length pushrod for proper rocker arm geometery