exhaust cutout
#3
I am not sure what you are speaking of, but if they are the same as "dump tubes," then they will give you more than you think....(and not just noise). Your basic dump tube is a Y-shaped 1-into-2 adapter that is either solenoid operated, or just a flange (plate) held on by wing nuts. They are usually located ahead of the cat for the least amount of backpressure. When you get to the track, open the tube for max performance.
The L67 is a good candidate for one. They work really well on FI cars (ask any serious GN owner). Also, backpressure isn't as much of an issue with a bigger motor like the 3800. There is enough displacement to keep the combustion chamber full at low RPM'* (again, something that L67'* don't have to worry about). USUALLY (and I say this sparingly) the only time you have to worry about having enough backpressure is in small displacement four-bangers (especially ones with fart cannons). You may notice a difference at low RPM'*, but will notice that the engine breathes much better as the tach swings to the right.
The L67 is a good candidate for one. They work really well on FI cars (ask any serious GN owner). Also, backpressure isn't as much of an issue with a bigger motor like the 3800. There is enough displacement to keep the combustion chamber full at low RPM'* (again, something that L67'* don't have to worry about). USUALLY (and I say this sparingly) the only time you have to worry about having enough backpressure is in small displacement four-bangers (especially ones with fart cannons). You may notice a difference at low RPM'*, but will notice that the engine breathes much better as the tach swings to the right.
#4
Senior Member
Certified Car Nut
Backpressure isn't good on any engine, at all. Going with too large an exhaust pipe lets the exhaust gases expand and cool so they don't go as fast.
You will run faster with it in the 1/4, you may lose some low end torque, but 3800'* have plenty IMO, and need more ontop (where you are going WOT). If you put it right before the muffler you're not doing as much as if say at the front of the pipe. Turbo'* do better then blowers with a huge exhaust because it helps keep the turbo spooling easier.
You will run faster with it in the 1/4, you may lose some low end torque, but 3800'* have plenty IMO, and need more ontop (where you are going WOT). If you put it right before the muffler you're not doing as much as if say at the front of the pipe. Turbo'* do better then blowers with a huge exhaust because it helps keep the turbo spooling easier.
#5
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Aug 2004
Location: Hawaii
Posts: 570
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BonneMeMN
Backpressure isn't good on any engine, at all. Going with too large an exhaust pipe lets the exhaust gases expand and cool so they don't go as fast.
#6
Senior Member
Posts like a Camaro
Join Date: Mar 2004
Location: Waterloo, NY
Posts: 809
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by dblack1
look at the exhaust on this http://www.goarmy.com/racing/nhra_top_fuel.jsp
I would say a cutout would only be good for track runs, but there are some mighty fast B'villes that run stock or slightly modified exhausts with cat & mufflers. One that comes to mind is Rogue with a 12.8@104mph and, as far as exhaust goes, he only has an aftermarket cat.
#7
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Aug 2004
Location: Hawaii
Posts: 570
Likes: 0
Received 0 Likes
on
0 Posts
actually the army top fuel dragster uses nitro instead of a blower.... if our exhaust is too open then we need to install a smaller sc pulley
#8
Senior Member
Posts like a Camaro
Join Date: Mar 2004
Location: Waterloo, NY
Posts: 809
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by dblack1
actually the army top fuel dragster uses nitro instead of a blower.... if our exhaust is too open then we need to install a smaller sc pulley
#9
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Aug 2004
Location: Hawaii
Posts: 570
Likes: 0
Received 0 Likes
on
0 Posts
yea i guess that one does have a blower on it... and nitro isnt fuel from what i understand about it, when it burns it releases oxygen therefore rasing compression
#10
Senior Member
True Car Nut
Top fuel cars don't burn nitrous oxide, if that'* what you're talking about. They use nitromethane (more specifically, a nitromethane blend) for fuel. Every Top Fuel and Funny Car on the circuit has a blower. They wouldn't even come close to winning without it. You might be able to visit some other sites to check out the specifics, because I really don't know all that much about it. I know the History Channel had an awesome Modern Marvels episode about drag racing. They rerun it every now and then, so definitely look for it if you get the History Channel.