Question about intakes...
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Jan 2003
Location: Stevens Point, WI
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Question about intakes...
I am going to make my own intake, using the ADTR one as a refrence. One thing I've noticed is that the manrel-bent tubing is 3-inch, and the silicone reducer is a 3.5" to 4"?? Why? Do they not make a 3" to 4" reducer? or will it just not fit?...
Another question:
What are the dimensions on the bent aluminum tubing?
Thanks!
Another question:
What are the dimensions on the bent aluminum tubing?
Thanks!
#2
Senior Member
Posts like a Northstar
Join Date: Aug 2002
Location: Toledo, Ohio 2002 SSEi
Posts: 602
Likes: 0
Received 0 Likes
on
0 Posts
I believe (and Hector can correct me if I am wrong) that the 3" is refering to the I.D. of the pipe. A 3 1/2" reducer is used because it is attached to the outside of the pipe which is 3 1/2" O.D.
#3
Senior Member
Posts like a Camaro
No, we use 4" to 3" reducers. Just gotta know where to get them. Sorry, I can't give those dimensions to you. We spend alot of $$$ on R&D to get these intakes just right.
Thread
Thread Starter
Forum
Replies
Last Post
nickycarts
Performance, Brainstorming & Tuning
9
07-24-2006 12:53 AM
CDecker
Performance, Brainstorming & Tuning
10
08-23-2002 12:58 PM