Specs for a 97 SSEi
#1
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Specs for a 97 SSEi
I'm setting up my software to do dynos. But I need accurate information to get the best results. What is the weight and drag coeff of a 1997 bonneville SSEi?
I ran with the stock setting in the software and it says I have 1064.36 RWHP and 1228.4 LB of torque. As much as I would like to say that, I think it'* off by just a little.
I did however get good 14 mile runs
60' 2.482 sec
0 to 60 8.080 sec
1/8 mile ET 10.481 sec
1/8 mile speed 70.443 MPH
1000' time 13.507 sec
1/4 mile ET 16.017 sec
1/4 mile speed 90.558 MPH
This is with no mods other then a intake. It will be interesting to see how that changes as I make mods.
Thanks
I ran with the stock setting in the software and it says I have 1064.36 RWHP and 1228.4 LB of torque. As much as I would like to say that, I think it'* off by just a little.
I did however get good 14 mile runs
60' 2.482 sec
0 to 60 8.080 sec
1/8 mile ET 10.481 sec
1/8 mile speed 70.443 MPH
1000' time 13.507 sec
1/4 mile ET 16.017 sec
1/4 mile speed 90.558 MPH
This is with no mods other then a intake. It will be interesting to see how that changes as I make mods.
Thanks
#3
Junior Member
Posts like a Ricer Type-R
Re: Specs for a 97 SSEi
Originally Posted by Danthurs
60' 2.482 sec <----need to work on track prep and launches. This should be 2.2 at the most
1/4 mile ET 16.017 sec <-----with the right prep and a good launch, this should be much closer to 15.0 than 16.0
1/4 mile speed 90.558 MPH
This is with no mods other then a intake. It will be interesting to see how that changes as I make mods.
Thanks
Drag Coefficient of 0.360, and a frontal area of 24.3 sq/ft
#5
Junior Member
Posts like a Ricer Type-R
#7
Junior Member
Posts like a Ricer Type-R
That question just hit me too, Fantastic. I smell a Gtech meter or something similar. If this is true, ditch the meter. They're a joke, and typically, even with painful setup calibrations in a lab, aren't accurate enough for tuning purposes.
If you're using a meter, let us know, and we'll explain the problems with them.
If you're using a meter, let us know, and we'll explain the problems with them.
Thread
Thread Starter
Forum
Replies
Last Post
Greg Symons
General GM Chat
4
12-29-2003 09:42 AM