Smaller Pulley
10-29-2008, 02:34 PM
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Oct 2007
Location: Cleveland, OH
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Smaller Pulley
Does anybody know how small you can go until you need an intercooler? I read that for a Thrasher 3 inch pulley, you WILL need an intercooler, but everything above 3 inches wasn't specified. If you get a 2.8 inch pulley, I was told you need to make accomodations for knocking, what exactly needs to be done?
10-29-2008, 02:46 PM
#2
Senior Member
Certified Car Nut
Join Date: Oct 2003
Posts: 19,756
Likes: 0
Received 0 Likes
on
0 Posts
ya you need alot of mods to run a 3" pulley.
if your stock dont even think about going under a 3.5.
to run a 3" or less, you need at least rockers, or cam, headers, FWI, and a Intercooler
if your stock dont even think about going under a 3.5.
to run a 3" or less, you need at least rockers, or cam, headers, FWI, and a Intercooler
10-29-2008, 02:56 PM
#3
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
I'm running rockers springs, headers, intake, shift kit, intense tuned PCM and I'm only down to a 3.2" And I still need to tune out a little bit of KR yet. Ypu have a long ways to go to get to a 3" pulley.
10-29-2008, 03:18 PM
#4
Member
Posts like a V-Tak
Thread Starter
Join Date: Oct 2007
Location: Cleveland, OH
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
wow, thanks alot guys. I was planning on doing all that anyway, but was going to try and do the pulley first. You guys just saved me a HUGE headache.
Thread
Thread Starter
Forum
Replies
Last Post
salmanman
Performance, Brainstorming & Tuning
21
03-27-2003 02:29 PM
DanCulkin
Performance, Brainstorming & Tuning
32
01-30-2003 03:01 PM