Cold Air Intake-IAT
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: May 2006
Location: Central Illinois
Posts: 360
Likes: 0
Received 0 Likes
on
0 Posts
Cold Air Intake-IAT
i just purchased the rice pipe and K&N filter and im about to do the custom intake but before i start i dont really know how to take the IAT out of the Factory Air Intake and do i need to put an extension on it?
#2
I've got a later model year and I don't know if it'* the same for you but taking the IAT out of the stock accordian tubing is just a matter of twisting, rocking, and pulling. Be careful, but it should come out. As far as mounting it goes, the best place is in the hole in the filter flange on the K&N RX-4750. That hole is a little bit too small so you'll have to bore it out some. If you don't know how to spilce and solder wires, you can buy an IAT extender (plug and play) from Intense since you'll need the wire to reach a lot further.
#5
Senior Member
Posts like a Turbo
Join Date: May 2003
Location: jacksonville, florida
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
I had my IAT wires extended but found out later I had plenty of wire to plug my IAT in to the RX-4750. Guess it depends on how long your rice pipe is and where it is positioned.
Thread
Thread Starter
Forum
Replies
Last Post
cballweg
Bonneville GXP/ Northstar Powered Cars
6
05-04-2006 02:37 AM