Are these the wires for out car
#2
Senior Member
True Car Nut
Join Date: Jul 2003
Location: Westerville, Ohio 2000 Black SSEi
Posts: 6,127
Likes: 0
Received 1 Like
on
1 Post
The wires are correct however you may want to check length of them. Obviously different mills have different dimensions so make sure these are cut for your 3800.
Ty at Domestic Performance can set you up with custom fit wires in dif colors as well...
-- Rogue
Ty at Domestic Performance can set you up with custom fit wires in dif colors as well...
-- Rogue
#5
Junior Member
Posts like a Ricer Type-R
Yup.
I don't see how that would cause a problem....might even make for a cleaner install. At least with the Series I factory headers anyway. I'm not sure how they'd clear the manifolds on a Series II.
I don't see how that would cause a problem....might even make for a cleaner install. At least with the Series I factory headers anyway. I'm not sure how they'd clear the manifolds on a Series II.
#7
Junior Member
Posts like a Ricer Type-R
No, straight boots for the plugs, 90° for the coils......unless those black ends are for the coils?
My Taylor'* have red plug boots on the red wires, straight, and molded.
My Taylor'* have red plug boots on the red wires, straight, and molded.
#8
Senior Member
True Car Nut
Join Date: Jul 2003
Location: Westerville, Ohio 2000 Black SSEi
Posts: 6,127
Likes: 0
Received 1 Like
on
1 Post
My boots to the plugs are molded as one piece(the color of the wire). They are part of the wire not additions. The boots to the coils are 90 degree black add-ons like the ones in your picture.
http://www.domesticperformance.com/p...433e20224eed34
Looks like the blue wire in this picture...
-- Rogue
http://www.domesticperformance.com/p...433e20224eed34
Looks like the blue wire in this picture...
-- Rogue
#9
Senior Member
Certified Car Nut
Join Date: Oct 2002
Posts: 11,308
Likes: 0
Received 0 Likes
on
0 Posts
Mine are like that too. I've seen one member (BonneMeMN I think) who reused the stock heat shields for the plug boots on his Taylors. His are straight at the plug but not molded like mine. The heat shields obviously wouldn't have fit on mine. I was curious how his were different.
#10
Senior Member
Certified Car Nut
Mine are black boots on both ends, i got mine from www.grandprixstore.com and they were only $50. Yeah they were black with 4 little black lines that stuck up running down the length on the plug end. On the coil side they are smooth and black. I Didn't take pix of the plugs before i covered them up i think, but i do like having those heat shields there...