Custom made downpipe question..
#1
Senior Member
Posts like a Camaro
Thread Starter
Join Date: Apr 2005
Location: montreal, Canada
Posts: 1,108
Likes: 0
Received 0 Likes
on
0 Posts
Custom made downpipe question..
This week i will order a set of ported manifold and i want to do my downpipe in the same time, i can have it done Mandrel bent and installed for 350$ can. is it a good price for a downpipe?
And i want to know if i need a 3 inch intlet on the high flow cat? or custom fit back to 2.5 inch.?
And i want to know if i need a 3 inch intlet on the high flow cat? or custom fit back to 2.5 inch.?
#2
Senior Member
Posts like a Corvette
Join Date: Jan 2004
Location: Montréal, QC
Posts: 1,374
Likes: 0
Received 0 Likes
on
0 Posts
$350 Cdn sounds about $100 too much.
Get a 3" downpipe with a 3" inlet and outlet for the catalytic convertor with a reducer behind the cat to 2.5".
Where did you get the quote?
Cheers,
Get a 3" downpipe with a 3" inlet and outlet for the catalytic convertor with a reducer behind the cat to 2.5".
Where did you get the quote?
Cheers,
#4
Senior Member
Posts like a Turbo
I actually have a place working on fabricating a DP for my car. I should know something by the end of the week on price, etc.
For my DP, I spec'ed them to fab a 3" mandrel bent pipe between the rear manifold to the stock flange on the cat inlet.
I'll post when I find out more details.
For my DP, I spec'ed them to fab a 3" mandrel bent pipe between the rear manifold to the stock flange on the cat inlet.
I'll post when I find out more details.
Thread
Thread Starter
Forum
Replies
Last Post