More projects
#1
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
More projects
More free time means more time to finish projects. First up, porting out the extra LIM I have. Ran it threw the parts cleaner, was a bit dirty.
Already opened up the inlet.
Just need to clean that all up.
Next up will be porting the outlets.
Then I just need to polish it all up and it will be done. Might put this up for sale when done.
Guess I should get started on these some day.
I think I might pull the valves and springs today, then get these cleaned up and start the porting.
Then I'm hopping to get going on this. Need to tear this all the way down and rebuild it.
Already opened up the inlet.
Just need to clean that all up.
Next up will be porting the outlets.
Then I just need to polish it all up and it will be done. Might put this up for sale when done.
Guess I should get started on these some day.
I think I might pull the valves and springs today, then get these cleaned up and start the porting.
Then I'm hopping to get going on this. Need to tear this all the way down and rebuild it.
#3
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
It'* way to nice out to be cooped up in the house, I would much rather be cooped up in my shop. So I went out to get started on those heads.
Off with the springs.
Here we are with the springs and valves all removed.
Going to have to pick up a few smaller bits to get down in there and port it out.
This is for reference for those wanting to port out their LIMs. You don't go more then .9" wide, and 1.9" tall, and this is why.
OK, got everything off, valves, springs, valve seals. Now I just need to get to the parts cleaner.
Off with the springs.
Here we are with the springs and valves all removed.
Going to have to pick up a few smaller bits to get down in there and port it out.
This is for reference for those wanting to port out their LIMs. You don't go more then .9" wide, and 1.9" tall, and this is why.
OK, got everything off, valves, springs, valve seals. Now I just need to get to the parts cleaner.
Thread
Thread Starter
Forum
Replies
Last Post
crzydmnd72
General GM Chat
44
02-17-2004 05:27 PM