99 Intrigue with Dual Climate Control. Drivers side does not blow any warm air. I am assuming it is a blend door servo. Can someone tell me where this is located? I would like to have a general idea before I start tearing things apart.

(1) Right Electric Actuator (w/ RPO CJ2 Only)
(2) Vacuum/Electric Solenoid
(3) Engine Vacuum Hose
(4) Blower Motor
(5) Blower Motor Control Module (w/ RPO CJ2) or Blower Resistors (w/ RPO C67)
(6) P100
(7) Heater-A/C Module
( Left Electric Actuator

It is where the connector shown in Justin'* picture as #8 plugs into. When I changed mine I pulled the driver'* seat out, which allowed me to lay on my back with my head under the dash. Make sure you line the flat on the pivot rod up with the flat in the actuator. Other than that, its not too difficult to change.

I bought the new one off Rock Auto.