Normal Maintainence Save a couple of bucks; here's how to perform the everyday oil changes, fluid flushes, and other maintenance that your GM car needs to last for a long time.

Oil and oil filter change

 
Thread Tools
 
Search this Thread
 
Old 03-04-2009, 03:10 PM
  #1  
Retired Senior Admin

Expert Gearhead
Thread Starter
 
Danthurs's Avatar
 
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes on 24 Posts
Danthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to all
Default Oil and oil filter change

To keep your engine in good running order you should change your oil ever 3000 miles or ever 3 months which ever comes first. (With standard oil)(Synthetic oil can be further between changes)

Make sure you have 4.5 quarts of oil and the correct filter.


Put your car up on ramps. You can use a jack, just make sure you have jack stands. Ramps are much safer and easier to use.


You will need a catch pan for the drain oil, a oil filter wrench, and a 15mm wrench for the drain plug.


Slide you catch pan under the drain plug and oil filter. The filter is on the passenger side.


Now take your 15mm wrench and remove the drain plug. It'* located on the back of the oil pan.


Once the plug is out the oil will drain out.


When the oil has slowed to a trickle you can remove the filter.


While that is draining dip your finger tip in to the drain oil and apply oil to the rubber seal on the new filter. This will prevent damage to the seal when you put it on. Cover the whole seal with oil.


Now put the new filter on. Put this on by hand, no tools are needed to tighten it. Simply make it as tight as you can by hand.


By now nearly all the oil that can drain out has come out. Inspect the tip of the plug for debris. Then put it back in the drain hole. make sure you tighten the plug.


Wipe up any oil left on the pan.


Slide your waste oil off to the side for disposal.


Now on top of the engine, locate your oil filler cap.


Twist to remove.


Use a funnel and fill the engine with 4.5 quarts of oil.


Replace the cap


Check under the car for any leaks. If you see none, then start your car. Check the oil pressure.


Let engine run for about a minute, then turn it off. Wait about a minute for the oil to drain back. Now locate your oil dip stick.


Pull it out, wipe it off, reinsert the dip stick all the way in. Pull it back out and check the level.
Danthurs is offline  
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jrsroadhauze
Buick
12
11-20-2010 09:22 PM
robert76
1992-1999
9
11-10-2005 12:43 AM
josho66
2000-2005
5
06-10-2005 07:06 PM
ssesc93
1992-1999
19
07-29-2003 11:14 AM



Quick Reply: Oil and oil filter change



All times are GMT -4. The time now is 12:47 PM.