What did you do with your car/truck or shop today?
#1481
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
I'm going to stop at autozone and get a new pickup coil for the truck. Still stalling out on me and I seem to have it narrowed down to that.
#1483
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Ya, but a easy fix, I hope.
Also need to check my wifes montana. When you turn the wheel half way left the ABS light comes on. Turn it right and no problem, it'* only left.
Also need to check my wifes montana. When you turn the wheel half way left the ABS light comes on. Turn it right and no problem, it'* only left.
#1485
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Well, rebuilt the distributor with a new pick up coil. Engine stalled same way. I thought for sure that was it. Well, I have the ICM, and coil to try yet. Then perhaps wires.
Ya Bill, I'm about to eat and then climb under and look around. Only cuts out on hard left turn.
Ya Bill, I'm about to eat and then climb under and look around. Only cuts out on hard left turn.
#1487
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
I found the wire on the left side had a little problem, no big deal, but it may have been the issue. There'* a clip that holds the wires as they come in to the plug. So with wires may have been moving. I clipped it in place and turned the wheel back and forth several times and the ABS light didn't come on. Time will tell.
#1488
Senior Member
Posts like a Corvette
0602011738.jpg
I can't leave it there when I drive around, but I could put it there when I go to the next car cruise/show. As long as no one is sitting in the back seat.
I can't leave it there when I drive around, but I could put it there when I go to the next car cruise/show. As long as no one is sitting in the back seat.
#1489
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
I replace the pickup coil on the truck today.
DSC04105.jpg
Talk about a HUGE pain. I had to take the whole distributor apart to change that one small part.
DSC04104.jpg
DSC04105.jpg
Talk about a HUGE pain. I had to take the whole distributor apart to change that one small part.
DSC04104.jpg
#1490
Senior Member
True Car Nut
Join Date: Jan 2011
Location: Michigan
Posts: 3,344
Likes: 0
Received 0 Likes
on
0 Posts
Tore apart a park avenues doors to get my speaker covers at a junkyard today, cut the holes in them, ill probably install them tomorrow, i dont feel like pulling my car apart today.