New Member, non Bonneville, but Eaton Powerd....... :lol:
#41
Hey, I've seen one way to make it possible to use a regular floor jack on a low clearance front like that. You cut a section out of the chin, then back the cut with sheet metal so you can run a flush-mounted fastener at either end. If you paint it to match, it'* not obvious, and you can pop out the notch in a few seconds at the track.
Thread
Thread Starter
Forum
Replies
Last Post
baggsend
Forced Induction
5
10-30-2003 02:23 PM
99BonnevilleSE
Performance, Brainstorming & Tuning
11
01-06-2003 08:28 PM