As
you begin to build performance in your car, your trans may become the
first victim. Knowing how happy it is can be a good thing, and may
point out potentially devastating consequences before they become fatal.
''
A transmission temperature gauge of your choice an be purchased from
most speed shops or The Grand Prix Store. The type of gauge is
irrelevant, you can choose whichever you like the best.
You will need to decide the location to mount the gauge, but an A-pillar
gauge mount is available as a professional location to mount two
gauges. Contact Grand Prix Store for details. These gauge mounts can be
purchased from The Grand Prix Store. Both 2 and 3 pod mounts are
available.
Begin by locating the throttle body. Just below it is the transmission.
On top of the transmission you will be able to see two "nipples". The
lower and closest to the firewall is what we are concerned with. This is
a pressure test port that can be used. There's a simple threaded plug
in there. Simply remove it with a ratchet.
Install the provided sending unit into the threaded port as shown below.
The small copper-colored sender with the gray wire is what we're
looking at here:
-- It should be the same thread size as the plug. Make sure it fits
snugly. Here's another look. You can see it in the back of the
transmission:
A tip when installing the signal wire is to put a few drops of removable
thread lock on the mounting nut to keep if from working loose. Install
the signal wire and route it securely away from the transmission.
Run the signal wire into the passenger cabin. There is a wire harness
that runs through the firewall just above the passenger's footwell that
is a good location for this wire.
Run the wire to the signal input of the transmission temperature gauge
inside the cabin and supply a switched power source for the backlight.
Another document is available that describes how to do this.
Don't forget to hook up 12V power. Why do you need 12V power? Because
the gauge is an electrical (unlike a boost gauge, for example, which is
mechanical). But I already hooked up my gauge lighting - isn't that good
enough? No - the power for the lamp is used only for the lamp. The
gauge needs an electrical signal that's not variable (unlike the dimmer
you already hooked up - it's not always 12V and varies with a turn of
the dimmer dial) so that it converts the signal from the sender into a
mechanical movement of the gauge needle. Here's how to do it.
Pop off the cardboard panel under the dashboard on the driver's side.
Pop the light out of the panel and move the panel out of the way.
Directly under the steering column, you'll see a small blue connector
with a few wires on it. Find the hot pink wire that is located as shown
below (it's hard to see in the small version, so click the picture to
view the larger version). Notice the position of this wire is the last
in the connector. There is only a small portion of this wire exposed, so
take care to do this right the first time. Tap into this line, and
connect this to your gauge for the power source (12V).
The passenger foot well area locates another possible 12-volt switched
source down. Remove the glove box door and slide out the glove box
assembly. Located at the back of the glove box compartment is a bundle
of wires taped to a support bar. This bundle is clearly marked at
AUXILIARY POWER DROP. In the drop is a 12 volt constant, 12 volt
switched, and ground. You can tap into these wires to provide power for
your gauges. This location is a little easier to work with, but does
require a bit more wire. Either location will work regardless. ''
Note that there are two types available. Mechanical and Electrical. I
suggest electrical. It's easier to install and troubleshoot.
Another option is the Aeroforce Scangauge if you have an OBD2 PCM
(96-current production). This nifty gauge can tell you trans temp and
many other things too.