Concerned Question
#1
Senior Member Emeritus
Posts like a Camaro
Thread Starter
Join Date: Feb 2005
Location: Grand Rapids, Iraq
Posts: 1,129
Likes: 0
Received 0 Likes
on
0 Posts
Concerned Question
I am workin on my custom CAI setup, what do you reccomend I do with the PCM. Wrap it? Im trying to figure what to do about it. and I attached the K7N filter almost directly to that piece of tube coming from the TB, so obviously need to get some of the insulation to help the heat stay out
#3
Senior Member
True Car Nut
Join Date: Sep 2004
Location: Fitchburg Ma _ToastedRice_
Posts: 6,837
Likes: 0
Received 0 Likes
on
0 Posts
post #483 about PCM protection. its fine, just make sure its secure.. Intense, and ZZP both sell brackets to snap it down. There is no need to shelter it from heat or the elements, it will be OK.
#4
Senior Member Emeritus
Posts like a Camaro
Thread Starter
Join Date: Feb 2005
Location: Grand Rapids, Iraq
Posts: 1,129
Likes: 0
Received 0 Likes
on
0 Posts
alright, I will have to pick up the tray tomorrow from ZZP, as for the heating issue for the cone[ which is a a solid circle, instead of the tapered one], need to insulate that as much as I can?
#5
Senior Member
True Car Nut
Join Date: Sep 2004
Location: Fitchburg Ma _ToastedRice_
Posts: 6,837
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Chad Vollmer
alright, I will have to pick up the tray tomorrow from ZZP, as for the heating issue for the cone[ which is a a solid circle, instead of the tapered one], need to insulate that as much as I can?
#6
Senior Member Emeritus
Posts like a Camaro
Thread Starter
Join Date: Feb 2005
Location: Grand Rapids, Iraq
Posts: 1,129
Likes: 0
Received 0 Likes
on
0 Posts
I made a custom holder similar to the thrasher intake, aside from the plexiglass top, sitting on the pcm[need a tray still]. Would it be a good idea to duct air from the fender into the enclosure?
#7
Senior Member
True Car Nut
Join Date: Sep 2004
Location: Fitchburg Ma _ToastedRice_
Posts: 6,837
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Chad Vollmer
I made a custom holder similar to the thrasher intake, aside from the plexiglass top, sitting on the pcm[need a tray still]. Would it be a good idea to duct air from the fender into the enclosure?
Thread
Thread Starter
Forum
Replies
Last Post