Part Identification...Please help
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Oct 2007
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Part Identification...Please help
Recently had a piece of plastic trim (right below the rear passenger door) come off and I realized it was because a couple of small plastic holding mechanisms had broken. I cannot find the Part #'* in order to get them from a GM parts dealer online. I was hoping someone could help me identify the Part # or where I could get them. Thanks so much
1. I need two of these
2. I need 4 of these
This is the piece of trim that came off that I need the holding mechanisms for
Trim piece flipped over
Thanks so much in advance for the help!
1. I need two of these
2. I need 4 of these
This is the piece of trim that came off that I need the holding mechanisms for
Trim piece flipped over
Thanks so much in advance for the help!
#2
Senior Member
Posts like a Turbo
Join Date: Nov 2009
Location: Brockport, New York
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
I'll see if I can help out.
Do these look like the right parts? This drawing is of the driver'* side of the car, but the other side should use the same clips and retainers.
I found it on http://www.gmpartsdirect.com/
Do these look like the right parts? This drawing is of the driver'* side of the car, but the other side should use the same clips and retainers.
I found it on http://www.gmpartsdirect.com/
#4
Senior Member
Posts like a Turbo
Join Date: Nov 2009
Location: Brockport, New York
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
cheri_marie
Everything Electrical & Electronic
10
05-24-2010 10:44 AM