Need some help
#1
Senior Member
True Car Nut
Thread Starter
Join Date: Feb 2004
Location: Pennsylvania
Posts: 5,177
Likes: 0
Received 0 Likes
on
0 Posts
Need some help
How do you remove the face plate that covers the unlock/lock and window controls on the drivers side? I disconnected the door lock wire allready, now I need to know how to remove the wires from the plate so they will be seperated??
#4
Senior Member
True Car Nut
Thread Starter
Join Date: Feb 2004
Location: Pennsylvania
Posts: 5,177
Likes: 0
Received 0 Likes
on
0 Posts
Yea, I got it off. I am painting them glossy black. It looks a lot better then the stock gray. I will get pics up when I am finished with the whole car.
#5
Senior Member
True Car Nut
Thread Starter
Join Date: Feb 2004
Location: Pennsylvania
Posts: 5,177
Likes: 0
Received 0 Likes
on
0 Posts
Haha, you know I was thinking about that, but I want to see how this looks for a little bit. I am also doing my trim on my dash and glovebox also. I went with glossy black and silver...it is looking pretty tight, and really flows with the car! I got everything drying off now. Back to the Pontiac emblem, I will probably put one underneath my hood on that carpet, like how some people have the SSEi logo on theirs.
#7
Senior Member
True Car Nut
Thread Starter
Join Date: Feb 2004
Location: Pennsylvania
Posts: 5,177
Likes: 0
Received 0 Likes
on
0 Posts
Yea, that would be tight. Just trying to get this done for now. And one piece of advice I found out, make sure you label the screws and where they go and dont lose any, or it could get really nasty!
Thread
Thread Starter
Forum
Replies
Last Post
OLDsman105
Performance, Brainstorming & Tuning
12
08-01-2006 06:20 PM
2000SilverBullet
Your Other Rides: Pics & Videos
6
07-02-2006 02:44 AM