Fall build
#1
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Fall build
Ok, I know I haven't even finished my spring build, but I got a great deal on this and couldn't pass it up.
Darn near killed myself getting it out of the trunk. Sure was easy putting it in, with a helper.
Looks like a had a body in the trunk. Guess I better not leave that in there.
Pulled a few pits out to lighten the load when I pulled it from the trunk.
All back together and in the corner.
Plan to get started on that after the spring build. I'm going to clean it all up and get a good coat of paint on it to make it pretty. I plan to upgrade to a 2750 torque converter, change the input shaft, more then likely change the clutches and bands, and change the gears. Think I may upgrade the axles as well. Plan to install in October, unless the trans in my car has other ideas.
Darn near killed myself getting it out of the trunk. Sure was easy putting it in, with a helper.
Looks like a had a body in the trunk. Guess I better not leave that in there.
Pulled a few pits out to lighten the load when I pulled it from the trunk.
All back together and in the corner.
Plan to get started on that after the spring build. I'm going to clean it all up and get a good coat of paint on it to make it pretty. I plan to upgrade to a 2750 torque converter, change the input shaft, more then likely change the clutches and bands, and change the gears. Think I may upgrade the axles as well. Plan to install in October, unless the trans in my car has other ideas.
Last edited by Danthurs; 02-25-2009 at 04:55 PM.
#3
DINOSAURUS BOOSTUS
Expert Gearhead
EP has been very slow on their diff'*...or they didn't like Wren. His 4T60 diff took then nearly a year to build.
Looking good Dan.. but please wiggle and push on the torque converter ...it looks like it'* not fully seated.
Looking good Dan.. but please wiggle and push on the torque converter ...it looks like it'* not fully seated.
#4
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
I just stuck it on there, I didn't even try to seat it. Now I need to watch for a set of gears. Any suggestions on the ratio? 3.29:1? Is it worth the extra $ to go with the 15/16 chain?
#5
DINOSAURUS BOOSTUS
Expert Gearhead
You may want to think about possibly bending the pump shaft or causing problems from hanging it incorrectly over a period of time. I would be concerned.
On chains, you'll want to read this thread about gear changes at BonnevillePro. Good info about the 15/16" and other options.
BonnevillePRO.com • View topic - Which is better: 2.93 vs. 3.29?
On chains, you'll want to read this thread about gear changes at BonnevillePro. Good info about the 15/16" and other options.
BonnevillePRO.com • View topic - Which is better: 2.93 vs. 3.29?
Thread
Thread Starter
Forum
Replies
Last Post
BonneAlien
Lounge
4
04-08-2003 12:36 AM