Where should I pull the driveline apart to stor this tranny?
#1
Senior Member
True Car Nut
Thread Starter
Join Date: Nov 2002
Location: Texarkana, Texas
Posts: 6,042
Likes: 0
Received 0 Likes
on
0 Posts
Where should I pull the driveline apart to stor this tranny?
I'm keeping the tranny from the 94 since it is the same ratio as mine, And I hear if I change some electronics I can make it work. I'll store it in my shed, But where should I pull it apart? Take the CV'* off? Just leave it all together? I want as much of it off as posible, but I don't want something important exposed...
#2
Senior Member
Posts like a Corvette
Join Date: Jul 2003
Location: Ardmore, Oklahoma
Posts: 1,590
Likes: 0
Received 0 Likes
on
0 Posts
you should be able to remove the cv'* and axles out of it and it will be fine, be careful if it has fluid still in it, you will be in store for a bath.
#3
Senior Member
True Car Nut
Thread Starter
Join Date: Nov 2002
Location: Texarkana, Texas
Posts: 6,042
Likes: 0
Received 0 Likes
on
0 Posts
Cool. I already got the engine basket sitting on the ground.
Just wondering how hard is it to bend an A-arm, cause the one on the drivers' side is waaaay folded back....
Just wondering how hard is it to bend an A-arm, cause the one on the drivers' side is waaaay folded back....
#6
Senior Member
Posts like a Corvette
Join Date: Jul 2003
Location: Ardmore, Oklahoma
Posts: 1,590
Likes: 0
Received 0 Likes
on
0 Posts
what i did was take two large screw drivers and put them behind where the axles insert and push out with the screw drivers. it is a PITA but it will eventually come out.
Thread
Thread Starter
Forum
Replies
Last Post