drilling into dash
08-20-2011, 04:10 PM
#1
Senior Member
Posts like a Camaro
Thread Starter
drilling into dash
ok so my dash i curling up by the windsheild really bad. im having the windsheild replaced today so it would be easy to do this while it was out.
i was thinking i would just put a few screws in it to hold it down. is there any wiring that far up in the dash i would have to worry about.
i was thinking i would just put a few screws in it to hold it down. is there any wiring that far up in the dash i would have to worry about.
08-20-2011, 05:12 PM
#2
Senior Member
Certified GM nut
I would assume the only wires up that high are the ones that go to the daylight sensor. I don't know if they run along the bottom of the dash, or if they go straight down..
08-20-2011, 08:06 PM
#8
Senior Member
True Car Nut
Join Date: Jan 2011
Location: Michigan
Posts: 3,344
Likes: 0
Received 0 Likes
on
0 Posts
there shouldnt be wires up there, i took a big chance when i took the sawzall to my hondas dash and all the wiring went up from the floor into the stereo and climate controls so i didnt hit anything, my buick on the otherhand would be a different story since all the dash lights run the full length of the dashboard across the top
Thread
Thread Starter
Forum
Replies
Last Post