Confused about gauge....
#1
Junior Member
Thread Starter
Join Date: Apr 2006
Location: Purgatory
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Confused about gauge....
Can anyone tell me what the markings are on the stock boost gauge? What are the marks between 0 and 5 and 5 and 10?
Sorry... I know this is a extremely stupid question. :?
Sorry... I know this is a extremely stupid question. :?
#3
Junior Member
Thread Starter
Join Date: Apr 2006
Location: Purgatory
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Alright so what is the stock boost on the 94? It seems like I'm not pulling full stock boost. :?
http://media.putfile.com/Flooring-with-180
http://media.putfile.com/Flooring-with-180
#5
Junior Member
Thread Starter
Join Date: Apr 2006
Location: Purgatory
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Ouch. I'm only boosting 6 psi. It goes as high as 6. It did boost to 8 before, but I think messing with the BCS screwed it up. Maybe I will put the BCS back to where it was before. :(
#7
Retired
Link worked fine on my end... You gotta get someone else or something to hold camera better.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#9
Junior Member
Posts like a Ricer Type-R
Low boost could be:
Faulty or poorly adjusted BCS.
Coating coming off the SC rotors.
Bad MAP sensor
Vacuum leak
PCM dumping boost for some other reason
You should see about 8psi, plus or minus 0.5 psi.
Faulty or poorly adjusted BCS.
Coating coming off the SC rotors.
Bad MAP sensor
Vacuum leak
PCM dumping boost for some other reason
You should see about 8psi, plus or minus 0.5 psi.