Ok my turn for a hi-flow..
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Mar 2006
Location: Fort Worth, TX
Posts: 399
Likes: 0
Received 0 Likes
on
0 Posts
Ok my turn for a hi-flow..
I was under the impression that typically an N/A SE would have a 2.25" inlet/outlet for the cat. However, when I measured with a crescent wrench, I got 2.5". Then, just for good measure (pun intended), I took a tailor'* tape measure around the pipe and divided by 3.14... I got 2.54". So I am assuming that my stock is 2.5" diameter. Is this normal on an SE? While I know there have been varying measurements all over the club ni this respect, I just thought I'd throw this out to the group and see what ya'll had to say.
I know that the car was originally sold with the tow package. I am planning on ordering a Magnaflow Hi-Flow cat tomorrow from HoganPerformance.com.
Thanks.
I know that the car was originally sold with the tow package. I am planning on ordering a Magnaflow Hi-Flow cat tomorrow from HoganPerformance.com.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
methatswho
Pontiac
3
03-15-2015 08:26 PM
ssesc93
1992-1999
13
09-25-2003 03:17 PM