No boost
#1
Senior Member
True Car Nut
Thread Starter
Join Date: Feb 2003
Posts: 3,684
Likes: 0
Received 0 Likes
on
0 Posts
No boost
Well actually there is boost but the needle has stopped moving. I just sits right below 0 on the gauge. It does do the swipe when the car is started other than that is doesnt move at all. How is the PSI read? My guess would be vacuum.
#2
Junior Member
Posts like a Ricer Type-R
MAP sensor. Turns the vacuum analog signal into a signal the PCM can read and pass on to the boost gauge. Check the vacuum lines around your MAP sensor (not sure on the S2 location, but probably near your FPR) and check the vacuum lines under the snout of the SC. S1 doesn't have one there, but you do.
Moving to Forced Induction.
Moving to Forced Induction.
#3
Senior Member
True Car Nut
Join Date: May 2005
Location: _Phoenix, AZ_ _WCBF '05, '06, '07 Survivor_ ____NEBF '07 Remnant___
Posts: 3,448
Likes: 0
Received 6 Likes
on
6 Posts
There are two MAP sensors on the back side of the engine, above the rear valve cover. Lines run from the SC snout, behind the alternator and to the MAP snesors. First sensor in line has a T-fitting and the line continues to an elbow at the second sensor. The fittings and line are underneath each sensor :?
Thread
Thread Starter
Forum
Replies
Last Post
Toddster
Trouble shooting + Test Procedures
0
03-21-2009 06:24 PM
DanCulkin
Performance, Brainstorming & Tuning
14
07-02-2007 11:02 AM
hvactech
Performance, Brainstorming & Tuning
12
05-10-2005 10:14 PM