Getting close
06-12-2003, 07:09 PM
#1
Junior Member
Thread Starter
Join Date: Jun 2003
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Getting close
I've got all the parts in the right places on the nosecone and am ready to put it back on. I have some question, though.
1. There are two bolts with pins extending out of them. Where do they go?
2. What do I use to seal where the nosecone meets the impeller housing?
3. I see Loc-tite is required. Where do I use the Loc-tite?
1. There are two bolts with pins extending out of them. Where do they go?
2. What do I use to seal where the nosecone meets the impeller housing?
3. I see Loc-tite is required. Where do I use the Loc-tite?
06-13-2003, 06:41 PM
#2
Member
Posts like a V-Tak
Join Date: May 2003
Location: Knoxville, TN
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Same Place
The pins are on top to hold the plastic cover that houses the wire harness 
that goes across the top of the SC. You put them back where you took them out 
Take the plastic wire harness cover, put it in its relative position with the hinge side towards the radiator. Then put the ones with pins in the respective holes.
Loctite 510 is the sealant, it'* not that easy to find. i found mine at Motion Industries where I found the bearings. You run a bead 1/16 " around each hole on the snout side and connect the circles.
that goes across the top of the SC. You put them back where you took them out Take the plastic wire harness cover, put it in its relative position with the hinge side towards the radiator. Then put the ones with pins in the respective holes.
Loctite 510 is the sealant, it'* not that easy to find. i found mine at Motion Industries where I found the bearings. You run a bead 1/16 " around each hole on the snout side and connect the circles.
Thread
Thread Starter
Forum
Replies
Last Post
TrueWildMan
Performance, Brainstorming & Tuning
20
06-15-2004 09:28 AM
Wolfedog50
Performance, Brainstorming & Tuning
3
05-08-2003 01:31 PM